Assign Part Revisions

Explanation

This activity is used to assign part revisions to a post maintenance check definition. When a serial part is assigned to the post maintenance check definition, all existing revisions of the part will be assigned automatically to the definition as well. You can remove the part revisions for which the post maintenance check definition is not valid and connect new part revisions that may be created at a later stage.

Prerequisites

• A post maintenance check definition must have been defined and the relevant serial parts should be assigned to it.
• To assign a new part revision, the part revisions must have been defined.

System Effects

• The post maintenance check definition is valid for the assigned part revisions.
• The post maintenance check definition can be activated. When the definition is activated, it can be connected to modifications and faults reported against the serials of the assigned part revisions, for which additional post maintenance checks should be carried out.
• Instructions and sign off requirements can be defined for the post maintenance check definition.
• If a part revision is added to or removed from an active post maintenance check definition, this change will be recorded in the journal for the definition.

Window

Post Maintenance Check Definition

Related Window Descriptions

Post Maintenance Check Definition
Post Maintenance Check Definition/Assign Part Revisions

Procedure

1. Open the Post Maintenance Check Definition window.
2. Search for the required post maintenance check definition.
3. Click the Assign Part Revisions tab.
4. To remove a part revision from the definition, select the row and delete (F7). Save the changes (F12).
5. To assign a new part revision, create a new record (F5) and enter required information as described in the following steps.
6. In the Part Number field, enter the part number of the assigned part. Use the List of Values to select a value.
7. In the Part Revision field, enter the new revision of the part. Use the List of Values to select a value.
8. Save the changes (F12).