Report Condition Measurement
Explanation
This activity is used to manually record condition
measurements for a serial. If the registered measurement is outside the defined
condition limits, you will receive a warning. A pending maintenance event is
created. A new cycle of measurement is started after the event is completed.
Prerequisites
- Condition limits must have been defined. For more information, refer the
activity
Define Condition Limits per Part Revision.
- If measurements are to be reported on a flight log
for a vehicle or a serial in its structure, the flight log must be in the
Open status.
System Effects
- When recording the condition measurement, a maintenance event is generated if the measured value exceeds the warning or danger
limits.
- A maintenance event is also generated if the change from the last
measurement is greater than the defined change limit.
Window
Serial Operational Information
Flight Log
Related Window Descriptions
Serial Operational Information
Serial Operational Information/Condition
Meas.
Serial Operational Information/Cond. Meas.
in Structure
Flight Log
Flight Log/Condition Meas.
Procedure
- Open the
Serial Operational Information window and query (F3) for
the necessary serial.
- Click the
Condition Meas. tab.
- In the Measure Value field, enter the measured value of the
condition. Note that the previous measurement appears by default and must be
overwritten with the new measure value.
- If needed, enter additional
information in the Measure Remark field.
- In the Measure Date
field, enter the date on which the condition measurement was completed. The
default value is set to today's date (i.e., system date) but can be changed.
-
Save the record (F12).
Follow this procedure to report measurement results
related to daily operations for an aircraft:
- Open the Flight Log window and
populate (F2) or query (F3) for your flight log number and/or serial.
- Click the Condition Meas. tab and
locate the serial for which condition measurements are to be reported.
- In the Measure Value field, enter the measured value of the
condition. Note that the previous measurement appears by default and must be
overwritten with the new measure value.
- If needed, enter additional
information in the Measure Remark field.
-
In the Measure Date
field, enter the date on which the condition measurement was completed. The
default value is set to today's date (i.e., system date) but can be changed.
-
Save the record (F12).