Perform Rename of Serials

Explanation

This activity is used to rename one or several serials when working on a work order created for a modification event leading to a part identity change. The activity can be performed several times until all serials have been renamed. You can also indicate if a rename should not be performed for a specific serial or you can reverse a rename which has been incorrectly performed.

Prerequisites

A work order with work tasks connected to a rename modification event must exist.

System Effects

Window

Work Task
Report In Work Order

Related Window Descriptions

Work Task
Work Task/Task Card
Report In Work Order/Work Tasks
Report In Work Order/Work Tasks/Task Card

Procedure

  1. Open the Report In Work Order window and query (F3) for the necessary work order.
  2. Click the Work Tasks tab, select the desired work task, and then click the Task Card tab. Alternatively, the Work Task/Task Card tab can be used to perform these steps.
  3. Right-click and then click Perform Rename of Serials. The Perform Rename of Serials dialog box opens.
  4. Select the Perform Rename check box if the serial should be renamed. This check box cannot be selected if the Rename Performed check box is already selected.
  5. Select the Undo Rename check box if the rename was done by mistake and needs to be reversed. This check box can only be selected if the Rename Performed check box is selected.
  6. Select the No Rename Needed check box if the serial should not be renamed after modification compliance. This check box cannot be selected if the Perform Rename or the Rename Performed check box is already selected.
  7. The Rename Performed check box indicates if the serial has already been renamed. The check box cannot be manually updated.
  8. Click OK.