Perform Condition Measurements

Explanation

This activity is used to record condition measurements on a work task. During execution of a scheduled maintenance it is possible to find abnormalities, such as, measurements that are outside the defined condition limits. When such measurements are found, you can use the functionality described in this activity to record the new measurements and initiate corrective action. When a measure value that is outside any of the defined condition limits is recorded, a maintenance event is created and added automatically to the work package (maintenance order) for the ongoing work scope. 

Note: If condition measurement requirements exist on a work task, these measurements must be performed before the work task can be completed.

Prerequisites

• The work task must exist in either the Released or Started status.
• Condition measurement requirements must exist for the work task. The Condition Measurement Required check box must be selected in the Task Card tab, e.g., Work Task/Task Card.
• Condition limits must have been defined for the serial connected to the work task.

System Effects

• Condition measurements are recorded on the work task. This information can be viewed in the Condition Meas. tab.
• The Condition Measurement Performed check box will be selected in the Task Card tab, e.g., Work Task/Task Card.
• If the measurement is outside the defined limits, a maintenance event is generated for it. The event will be added automatically to the maintenance order for the ongoing work scope.
• The condition measurements reported on the work task will be transferred automatically to Fleet and Asset Management and a history record will be generated.

Window

Work Task
Prepare Work Order
Report In Work Order
Work Order Execution Logic   

Related Window Descriptions

Work Task
Work Task/Condition Meas.
Prepare Work Order/Work Tasks
Prepare Work Order/Work Tasks/Condition Meas.
Report In Work Order/Work Tasks
Report In Work Order/Work Tasks/Condition Meas.
Work Order Execution Logic/Work Tasks
Work Order Execution Logic/Work Tasks/Condition Meas.

Procedure

1. Open the Report In Work Order window and search for the desired work order.
2. Click the Work Tasks tab, select the desired work task, and then click the Condition Meas. tab.
3. Right-click and click Perform Condition Measurement. The Perform Condition Measurement dialog box opens.
4. In the Measured Value field, enter the measured value of the condition. Note that the previous measurement appears by default and must be overwritten with the new measure value.
5. In the Measured Date field, enter the date on which the condition measurement was completed. The default value is set to today's date (i.e., system date) but can be changed.
6. Click OK.
7. Verify your changes in the Condition Meas. tab.

Note: This activity can be performed from the following tabs as well: Work Task/Condition Meas., Prepare Work Order/Work Tasks/Condition Meas., and Work Order Execution Logic/Work Tasks/Condition Meas..